OPERATING INSTRUCTIONS
UNPACKING & SET-UP SUMMARY
1 .Puillid latches
in
an
outward motion, remove power head and some accessories that
may have been shipped
in
the tank.
2 .Attach caster
following the instructions as below:
a.lnvert
dust tank, take the caster to align the tank bottom sinking place.
Secure
with screws provided.
b.Return dust tank
assembly upright.
3.Before
replacing power head, refer to this manual to ensure you have
the proper
filters installed for the cleaning operation.
4.Replace power head, and apply pressure with thumb to each latch until it
snaps
tightly
in
place. Make sure all lid latches are clamped securely.
5.lnsert
the hose end into inlet
of
tank.
6.Attach the extension wands to the end
of
the hose. Apply slight pressure until
fitting is tight.
7.Attach one
of
the cleaning accessories (depending on the cleaning requirements) on
the extension wands. Twist
slightly to tighten the connection.
8.Plug the cord into the wall outlet. The cleaniner is ready for use.
9.Turn the unit
"ON" by pushing the switch from position
"0"
to position "I". The
"0"
is
the
"OFF" position and the "I" is the "ON" position.
O=OFFI=ONe
AWARNING!
To reduce the risk
of
fire
or
explosion, do not operate this vacuum
in
areas with
flammable gases, vapors
or
explosive dust
in
the air. Flammable gases
or
vapors
include but are not
limited to: lighter fluid, solvent-type cleaners, oil-based paints,
gasoline, alcohol
or
aerosol sprays. Explosive dusts include but are not limited to: coal,
magnesium, aluminum, and grain
or
gun powder. Do not vacuum explosive dust,
flammable or combustible liquids
or
hot ashes. Do not use this vacuum as a sprayer for
any
flammable
or
combustible liquid. To reduce the risk
of
health hazards from vapors
or
dusts, do not vacuum toxic
materi~ls.
AWARNING!
The operation
of
any utility vacuum can result
in
foreign objects being blown into the
eyes, which can
result
in
severe eye damage. Always wear safety eyewear complying
with ANSI Z87.1 (or
in
Canada, CSA Z94.3) before starting operation.
ACAUTION:
To reduce risk of hearing damage, wear ear protectors when using the vacuum for
extended hours
or
when using it
in
a noisy area.
6
To Next Page
Loading...
