14- ENG
DAILY STARTUP (Figure 6)
1. Turn the pressure switch to the OFF position (A).
2. Close the tank drain valve (B).
3. Plug in the power cord (C).
High temperatures are generated by the electric
motor and the pump. To prevent burns or other injuries, DO NOT
touch the compressor while it is running. Allow it to cool before
handling or servicing.
Keep children away from the compressor at all times.
When adjusting from a higher to a lower pressure,
turn the knob counterclockwise past the desired setting, then
turn clockwise to reach the desired pressure.
Do not exceed operating pressure of tool or accessory used.
4. Turn the pressure switch to the AUTO position (D).
5. Adjust air pressure regulator to the working pressure of the tool being used.
SHUTDOWN (Figure 6)
1. Turn the pressure switch to the OFF position (A).
2. Unplug the power cord (C).
3. Reduce pressure in the tank through the outlet hose. You can also pull the
relief valve ring (E) and keep it open to relieve pressure in the tank.
4. Drain water from the air tank, open drain valve under the tank (B).
Escaping air and moisture propel debris that may
cause eye injury. Wear safety goggles when opening drain valve.
Figure 6
E
D
A
OPEN
CLOSE
B
C
(counterclockwise)
To Next Page
Loading...
