SERVICE MANUAL
Page 11
Service manual Jetstream Mk3 - V. 1.0 - 11-02-08 Approved by: JN
JETSTREAM Mk3
5. CLEANING INSTRUCTIONS
Jetstream Mk3
If corrosion or salt deposits occurs on metallic parts, place them in an ultrasonic washer for
the period of time recommended by the manufacturer of the liquid used or immerse part in
concentrated Hempocid* or 15% Hydrochloric acid for about 10 minutes. Then rinse them
thoroughly in fresh water and blow them dry with air. The synthetic parts must not be treated
with solvents and must only be cleaned with fresh water.
*Hempocid=Acid Liquid detergent containing phosphoric acid (5-10%) and bactericide for
disinfectant cleaning
The safety of your customer and yourself depends on you carefully and strictly following these instructions.
Negligence in any step can cause serious injury or even death.
Make absolutely sure Hydrochloric acid is NOT poured into the ultra-sonic cleaner. It would then destroy the
ultra-sonic cleaner and the parts attempted to be cleaned.
To Next Page
Loading...
