SERVICE MANUAL
Page 12
Service manual Jetstream Mk3 - V. 1.0 - 11-02-08 Approved by: JN
JETSTREAM Mk3
6. ASSEMBLY INSTRUCTIONS - SECOND STAGE 0120-005
Lubricants shall be used sparsely. Excessive quantities of lubricant can trap particulate and other
contaminants developing apotential re hazard.
Parts marked with the
symbol are parts that must be replaced at every service. New parts should be
stored in it’s original packing until it is time for assembly.
Step Parts Tools/Instructions Replace Picture
1
2578
Diaphragm (24). Check that the sealing surface
of the diaphragm is even. Also check that there
are no holes in the diaphragm and that the
diaphragm washer is properly fixed in position.
2
3202
The mouth piece (16). Make sure there are no
cracks.
3
2853
The purge button (27).Make sure
there are no cracks. Check to make sure
the spring is undamaged.
4
2786
Servo valve (14). Check to make sure that the
valve bar is not bent.
5
The switch: Put the switch into - and +position.
It should be moved rather slowly, control the
position of the diaphragm and that it is properly
tighten.
BEFORE ASSEMBLY, CHECK THE FOLLOWING
To Next Page
Loading...
