SERVICE MANUAL
Page 9
Service manual Jetstream Mk3 - V. 1.0 - 11-02-08 Approved by: JN
JETSTREAM Mk3
4. DISASSEMBLY INSTRUCTIONS - SECOND STAGE 0120-005
Step Parts Tools/Instructions Replace Picture
1
0000-130
Disconnect the low pressure hose from the LP
hose adapter and remove the LP hose adapter
2
3088
Remove the low pressure valve from the
housing with a screwdriver.Make sure the servo
valve needle is not bent. Be sure to hold the low
pressure valve carefully, to avoid dropping it
(see figure).
3
3202
1167
Cut off the locking strap (17) with cutting pliers.
Remove the mouth piece (16).
4
2851
Unscrew the 4 screws (26) with a 3.5 mm
screwdriver.
5
2578
2989
Remove the cover (25) and the diaphragm (24).
6
2853
Remove the purge button (27).
7
2711
1851
2794
2712
IMPORTANT
The switch should not be removed if it is
undamaged.
Removal:
1. Pull out the diaphram cam (22).
2. Cut off the switch (18) with a pair of cutting
pliers close to the locking washer (21). Remove
the switch.
3. Remove the o-ring (19).
To Next Page
Loading...
