POSIFLEX CD-3600 - General Options Configuration

- 4 -
Each 3-character command should be preceded with the '[' character (Hex 5B) i.e.
<Esc>[BCC<CR> is used to enable Data Matrix.
Each 4-character command should be preceded with the ']' character (Hex 5D) i.e.
<Esc>]DIAU<CR> is used to disable auto connect.
<CR>
<CR> is the ASCII CR character (Hex Ø D).
Z2
Some options are not immediately active, like baud rate settings. Most other options
are immediately active, but the command Z2 must be send to store the settings to
non-volatile memory.
The following commands may be used to:
Command B sound a good read beep
Command E sound an error beep
Command G motor off
Command H motor on
Command L switch on good read LED
Command N switch on bad read LED
Command O switch on both LEDs
Command Y de-trigger the reader
Command Z trigger the reader
The characters transmitted must be separated by an intercharacter delay to allow the
reader to process each character received and to execute the command string.
Package Content
CD-3600
 CD-3600 2D Image Scanner
 USB cable
 Quick setup guide
CD-3600S
 CD-3600 2D Image Scanner
 RS-232 cable
 Quick setup guide
CD-3600-SK
 CD-3600 2D Image Scanner
 SK-300 external bracket
 USB cable
 Quick setup guide