Installing the LD-2000 Light Bar (Optional)
Follow the steps below to install the LD-2000 light bar on the PP-7600 printer.
Power off the printer when installing the LD-2000 light bar.
1. Determine that the micro USB connector of
the cable for LD-2000 to PP-7600 is
securely connected to the micro USB port on
the LD-2000 control board.
2. Plug the L-formed header of the LD-2000 power cable into the LD-2000
power jack of the PP-7600 printer.
3. Make the four joints formed on the LD-2000 wedge to the four wedge
grooves formed on the PP-7600.
4. Determine that the LD-2000 securely
connects to the PP-7600.
To Next Page
Loading...
