29 30
Mobile Version
1. ToneCloud - Enters the ToneCloud page.
2. Effects page - Switches among your installed software packs. Available software packs
include Distortion Pack, Delay Pack and Modulation Pack.
3. Preset menu - Shows the current preset. Press to open the preset menu.
4. Save button - See the Save Preset section of this manual for more information.
5. Setting Menu - See the Settings section of this manual for more information
6. Tooltip - Helpful tips explaining each button and knob.
7. Signal Path - See the Signal Path section of this manual for more information.
8. Input volume - Controls the input volume. To prevent feedback, the input volume will be
muted at startup when using a built-in microphone and speaker as the chosen audio
input/output device
9. Tempo - Shows the current BPM value. You can set the BPM by entering the desired value
or by using the built-in tap tempo feature. The BPM range goes from 40 to 400.
10. Quick Snap - - Provides 8 slots to save and instantly recall different parameter setups for
instant comparison of different settings.
11. Noise Gate - See the Noise Gate section of this manual for more information.
12. Amp Room - See the Amp Room section of this manual for more information.
13. Amp Room - See the Amp Room section of this manual for more information.
14. Output volume - Controls the output volume.
15. Design button - Customize the look of your pedal. See the Custom Panel section of this
manual for more information.
16. Open in BIAS FX - Import current pedal to BIAS FX. Needs BIAS FX mobile.
1 2 3 4 5 6 7
9 10 11 12 13
14
8
15
16
To Next Page
Loading...