Potensic D60 - Advanced Troubleshooting and Compliance; Control Difficulties and GPS Issues

15
Hard to control
by cellphone.
7
Not experienced enough.
Practice and read the cellphone
controlling instruction carefully.
Can’t position
hold.
9
Whether the GPS has
connected or not.
Search again to connect the GPS
signal.
Searched but
could
not nd the
GPS signal
10
1. GPS module is damaged.
2. Poor connection
1. Please replace a new one.
2. Please check to see if the GPS module
is connected normally.
Can’t
altitude
hold.
8
1. The propeller is seriously
deformed.
1. Replace propeller.
2. The motor is damaged. 2. Replace the motor.
3. Atmospheric pressure
is not stable.
3. Refer to “Altitude Hold
Mode”instruction.
FCC Note
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
● Reorient or relocate the receiving a ntenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit dierent from that to which
the receiver is connected.
FCC Notice:
FCC Radiation Exposure Statement
WARNING: Changes or modications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
The equipment may generate or use radio frequency energy. Changes or modications to this
equipment may cause harmful interference unless the modications are expressly approved in the
instruction manual. Modications not authorized by the manufacturer may void user’s authority to
operate this device.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired
operation.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition with out restriction.
MADE IN CHINA
www.ipotensic.com
http://www.ipotensic.com