1. Switch on the heating emergency switch.
2. Open the gas tap.
3. Open the disconnector valves.
4. Open the domestic water supply.
5. Open the front panel cover and switch the ON/OFF switch on the front
panel of the boiler to on.
The Paramount can be put into operation without further settings being
necessary. For information regarding setting e.g. an individual time
program, please see the
Operation
chapter.
For more information, see
Changing parameters, page 56
8.6
Setting the heating mode
The operating mode key for heating mode enables a changeover between
the various heating operating modes. The selected setting is marked with
a bar underneath the operating mode symbol.
Automatic mode
Heating mode according to time program
Temperature setpoints or according to time program
Protection functions (plant frost protection, overheating protection)
activated
Automatic summer/winter changeover (automatic switching over
between heating and summer operation from a certain outside
temperature onwards)
Automatic day heating limit (automatic changeover between heating and
summer operation, if outside temperature exceeds the room setpoint
value)
Continuous mode or
Heating mode without time program
Protection functions activated
Automatic summer/winter changeover is not activated
Automatic day heating limit is not activated
Protection mode
No heating operation
Temperature according to frost protection setpoint
Protection functions activated
Automatic summer/winter changeover active
Automatic day heating limit active
8.7
Adjusting domestic water mode
Switched on Domestic water is prepared according to the selected
switching programme.
Switched off Domestic water preparation has been de-activated.
8 Operation
58 Paramount five 30 – 115 7703046 - 01 - 23072018
To Next Page
Loading...
