rrra,a:-:
:l -::-':-^: ]^ -p anc OO!Vn
the
: - a,',
-
':
::a :- S al !.6trnenl D€tore
yOU
:r= i
-
-
---:
-,:
:-€
car onto
the
saw. see
Insroe
view o1
cl
utch
cover
5
\
.,
Bar bolts
\
"...
.,\
Guide bar \-
'
6. Carefu ly
remove
the chain from
the
pack-
age
Hold
charn with the
drive
links
as
shown
Cutters
Depth
Gauge
Drive
Links
Place
chain over and behind
clutch
re-
tainer. fitting the
drive
links in
the clutch
orurn sprocKet.
Ft
botlom of drive links between the
teeth in
the sprocket in the nose
of
the
guroe
Dar.
Fit
chain drive
links
inlo bar
groove.
Pull
guide
bar forward until chain is snug
in
guide
bar
groove.
Ensure all drive
links
are in the
bar
groove.
Now. rnstall clutch
cover
making
sure
the
adJUSting
pin
is
positioned
in the low
er
hole in
the
guide
bar. Remember this
pin
moves the
bar
forward
and back-
ward
as the screw is turned.
: -::-e-t
located
on clutch cover
Adlust
ng Ptn
--'r
rne adjusting screw by hand coun-
:.'clockwise until the adjusting
prn
lust
:ouches
the
stop.
This
should allow the
prn
to be
near
the correct
posrtion.
Slide
guide
bar on
bar
bolts until
guide
bar stops against clutch drum sprocket
\
Clutch
Cover
12.
Install bar
nuts
and finger tighten only.
Once
the charn is tensioned.
you
will
need
to tighten bar nuts.
CHAIN
TENSION
(lnclud
ng units with chain
already
installed)
A
wnnrutruc: wear
protecrrve
groves
when handlang charn. The
chain
is sharp and
can cut
you
even
when it is
not moving.
NOTE: When
adjusting chain tension,
make sure the
bar
nuts
are
finger
tight only.
Attempting to tension
the chain when the bar
nuts are tight can cause
damage.
Checking the tension:
Use the screwdriver end of the
chain adjust-
ment tool
(bar
tool) to move
charn around
guide
bar. lf the
chain does
not rotate, it isloo
tighl.
lf
the chain
is
too loose, itwill sag below
the
bar.
.fi#
Chain
Adlustmen
Bar Nuls
Adrustino
^
Tool
'S;;;"
tBar
Tool)
Adjusting the
tension:
Chain tension is very important.
Chains
stretch during use. This rs
especially true
dunng the first few
times
you
use
your
saw.
Always
check chain tension each time be
fore
you
start the
chain saw.
1 . Loosen bar nuts u ntil
lhey are
fi nger
light
against the clutch cover.
2. Turn adjusting screw
clockwise until chain
solidly contacts
bottom of
guide
bar
rail.
9
10
CUTTEFS MUST FACE IN
DIIRECTION
OF
ROTATION
t1
To Next Page
Loading...
Need help?
General
