U P
UP
ASSEMBLY INSTRUCTIONS
8
1. Hold the middle frame (B) so that the screw holes
align with the holes on the lower frame (A).
Note: Make sure the middle frame is held upright,
following the UP mark attached to the middle frame.
Holding the middle frame in the reverse direction will
prevent proper assembly.
B
A
1
2
2. Insert the joint fixing bolt (AA) with the metal washer
(BB) into the aligned holes on each side. The metal
washer (BB) should be inserted outside of the frame.
BB
AA
B
A
Hardware Used
AA
x 2
M8 x 45 Joint fixing bolt
BB
x 2
DIA. 8 Metal washer
3. Use the joint fixing knobs (CC) to secure the
connection. The joint fixing knobs (CC) should be
inserted outside of the frame.
3
Hardware Used
CC
x 2
M8 Joint fixing knob
CC
BB
AA
To Next Page
Loading...
