Doors
1. Your shed will come with two doors which you will need to hang.
The door with the lock on will go on the right (as you look at the shed from the outside) and the door
with the shoot bolts will go on the left.
2. Position one of the doors in place ensuring the gap between the edge of the door and the shiplap
tongue and groove cladding (which you will be screwing the doors in to) is approx. 5mm. This is the
same for the top of the door where the gap should also be approx. 5mm.
3. Ensure that it is square and when you are happy with the position, secure the hinges in place using the
25mm screws provided.
4. Repeat this process with the other door.
5. Choose a place above the door to secure your turn button.
Be careful not to screw this too tightly or it will not turn.
To Next Page
Loading...
