PowerBase 577147 - Operating the Shredder; Initial Operation Checks; Powering On and Off

15
Fig. 2 Fig. 3
Before starting the device, make sure that the shredder unit is firmly
attached to the chassis, and the collection box and safety switch are
in the correct positions.
The shredder will not switch on unless the collection box and the
safety switch are in their correct positions.
Make sure that the mains power voltage corresponds to the
information on the rating label on the shredder. If your shredder
is fitted with a long mains cable, you can plug this directly into a
suitable power supply, using an RCD device if necessary.
Operation
Switching the shredder on and off
Operating Instructions & Tips
1
13
12
4
12
ON
OFF
Fig. 4