www.powerbox-systems.com 29
stick is moved, Attitude Assist is disabled, and the model ‘feels’ perfectly normal.
Once the Setup Assistant has been completed, Attitude Assist is active on aileron
in range B by default.
• Characteristic
Changing this value hardens and softens the regulatory behaviour of the iGyro. If
the model appears to respond too abruptly in gusty conditions, you should chan-
ge the value in the direction of Soft. If you think that the iGyro responds too slowly
to gusts of wind, change it in the direction of Ultra.
• Stick Priority
The default value for this menu point is 100%, which means that the gyro function
is completely suppressed when the stick is moved to its end-point. If you set stick
priority to 200%, for example, the gyro function will be completely suppressed
when the stick is at half-travel. The result is a more agile model, but at the cost of
a faster reduction in gyro effect as the stick movement is increased.
• Lock feel
This feature affects the model’s ability to ‘lock’ in manoeuvres such as four-point
rolls. If the value is set too high, the result is a tendency to overshoot or oscillate
at the moment the stick is released. If the value is too low, the locking may not
appear sufciently sharp.
• Airspeed Factor
This value denes the effect of speed-dependent variation in gyro gain. The set-
ting only applies if a GPS III or PBS-TAV is connected to FastTrack as well as an
iGyro SAT. The airspeed factor should be increased if the model displays good
gyro response at low to medium speed, but tends to oscillate at high speeds. Over
the years the default value of 4 has proved ideal for all kinds of model.
• Learning the installed orientation
In this menu the unit learns the installed orientation of the iGyro SAT. In most
cases this has already been established in the Setup Assistant, but if you change
the location or the orientation of the iGyro SAT, you will need to use this menu
point again.
To Next Page
Loading...
Need help?
General
