30 PowerBox-Systems − World Leaders in RC Power Supply Systems
The orientation of the gyro is established by moving the model in the directions
shown on the screen: to ensure that detection is absolutely reliable, move the
tail of the model smoothly up and down several times before holding the tail up
until the elevators return to neutral. The direction of effect is not important at this
stage.
Repeat the procedure with movement of the rudder: move it left and right repea-
tedly, then hold it in the “right” position.
• Learning the transmitter stick end-points
This setting is very important, and should always be carried out if you alter the
centre or end-points of the aileron, elevator or rudder gyro functions.
Follow the instructions on the screen to learn the stick end-points. Please note
that you must select the stick you wish to learn, and hold it at its end-point while
you press the SET button.
Note: With larger models this procedure can be awkward to carry out. Ho-
wever, there is a simple trick which makes establishing the installed position
easier: don’t x the iGyroSAT in the model until after the learning process is
complete. During the learning procedure you simply move the iGyroSAT in the
appropriate direction, rather than the model itself!
To Next Page
Loading...
