12. Specification
Operating voltage: 4.0 Volt to 9.0 Volt
Power supply: 2 x two-cell LiPo battery, 7.4 Volt
2 x five-cell NiCd / NiMH batteries,
2 x two-cell LiFePo batteries (A123)
Current drain: switched on - approx. 125 mA
switched off - approx. 33 μA
Dropout voltage: approx. 0.25 V
Max. receiver and
servo current: 2 x 10 A (stabilised)
according to cooling
Peak 2 x 20 A
Servo signal resolution: 0.5 μs
Signal repeat rate: 9ms, 12ms, 15ms, 18ms, 21ms
(frame rate)
Screen: OLED 128 x 64 pixels, graphic
Servo sockets: Competition: 18 sockets, 14 channels
Cockpit: 21 sockets, 12 channels
Temperature range: -30°C to +75°C
Weight: 115 g
SensorSwitch: 15 g
EMV approval: EN 55014-1:2006
CE approval: 2004/108/EG
WEEE Reg. No.: DE 639 766 11
This battery backer fulfils the EMV protective requirements, EN
55014-1:2006 with certificate dated 10 February 2009. EMC
approval 2004/108/EG.
The unit must not be connected to a mains PSU!
The PowerBox Cockpit/Competition SRS is intended exclusively for
use in modelling applications. It is prohibited to use it for any purpose
other than in radio-controlled models.
-31-
To Next Page
Loading...
Need help?
General