-09-
- Switch both batteries on.
- Press the SET button and hold it pressed in until the following display
appears:
- Press button II until the cursor (hollow circular ring) lines up with
Power Manager, then press the SET button. The following display
now appears:
If you wish to change one of the settings, use buttons I and II to move
the cursor to the appropriate menu point, then press the SET button to
select it (cursor changes to a solid disc). You can now alter the value
using buttons I and II. Once you have selected the desired value, press
the SET button to confirm it; this saves (stores) the new value. Select
the menu point OK to return to the main menu.
NOTE: the presence of a solid disc (instead of a ring) indicates that you
are in a menu point.
It is possible to alter a value more quickly by holding one of the two
buttons I or II pressed in; the value then starts to change slowly in the
corresponding direction, and the rate of change accelerates with time.