60
61
securely encrypted using Bluetooth
AES-128 encryption protocol.
DISCONNECTIONS AND
QUALITY OF SERVICE
PowerDot Mobile Application
and PowerDot PD-01M Bluetooth
communication interface are specifically
designed to accommodate temporary
and permanent Bluetooth disconnections
during a stimulation session.
PowerDot PD-01M device is capable of
independent execution of a pre-loaded
stimulation program with the latest
intensity values as well as implement
automatic Bluetooth® reconnections.
In this regard, temporary radio
frequency interference (e.g. caused by
co-existence of multiple Bluetooth and/
or Wi-Fi devices in your range) will not
affect the overall efficiency and safety of
your stimulation.
Due to hardware-level emergency stop
mechanisms (see Directions For Use),
Bluetooth disconnections of a more
permanent nature should not affect
the safety of stimulation, and can only
cause a temporary inconvenience by
forcing you to postpone your planned
BLUETOOTH
®
COMPATIBILITY
The unique feature of PowerDot PD-
01M device is that it’s controlled through
Bluetooth Low Energy wireless radio
interface.
PowerDot PD-01M is specifically
designed to be used together with
PowerDot Mobile Application, which is
supported for select Android and iOS
mobile devices.
SECURE PAIRING
Your PowerDot PD-01M device is
paired with your mobile phone using
secure numeric code which, by design,
prohibits any other mobile phones or
wireless devices to connect to your
PowerDot. Secure pairing takes place
during PowerDot activation process (see
Activating PowerDot above) and, once
your PowerDot becomes active, numeric
activation code is written into PowerDot’s
flash memory and gets verified by your
PowerDot Mobile Application after
every PowerDot restart.
All Bluetooth commands sent from your
mobile phone to PowerDot device are
TROUBLESHOOTING
WIRELESS CONNECTIVITY
If you run into issues with Bluetooth
wireless connectivity (e.g. your PowerDot
PD-01M device becomes unresponsive
to PowerDot Mobile Application
commands during stimulation session
or you were not able to connect to your
PowerDot and initiate stimulation), do
not panic and consider terminating
your stimulation session manually by
shortly pressing Power button on your
PowerDot device.
Your PowerDot Mobile Application has
built-in re-connection and disconnection
detection mechanism and, in most cases,
it will re-connect back to your PowerDot
shortly and allow you to resume your
stimulation using Resume button on the
stimulation screen.
If you fail to re-connect and resume
stimulation after several attempts,
consider stopping your stimulation
session using Stop button on the
Stimulation Screen and postponing it for
later.
stimulation session until a more favorable
Bluetooth connectivity environment is
established.
Like any wireless device, PowerDot PD-
01M emits very low levels in the radio
frequency (RF) interval, and is therefore
not likely to cause any interference
with nearby electronic equipment (e.g.,
radios, computers, telephones etc.).
PowerDot PD-01M is designed to
withstand foreseeable disturbances
originating from electrostatic discharges,
mains supply magnetic fields, or radio
frequency transmitters.
Despite this, it is not possible to
guarantee that the stimulator will not be
affected by strong RF (radio frequency)
fields emitting from other sources.
Try not to use PowerDot
PD-01M closer than 1.5
meters to the working
microwave oven as
radio interference from
microwave is likely to
cause disconnection
between PowerDot and
your mobile phone.
To Next Page
Loading...
