11 GB/IE/NI
To insert the battery proceed as follows:
Open the battery compartment cover
13
on
the back of the product. You can remove the
used battery more easily with the aid of the
material strip, which is inside the battery
compartment
14
. Just pull on the material strip.
Remove the battery clip from the battery
Plug the contacts of the 9 V-blockbattery on
the contacts of the battery clip. Make sure
you fit the batteries the right way round. This
is specified by the profiled shape of the con-
tacts. Also ensure without fail that the material
strip is underneath the battery.
Insert the battery in the battery compartment
and close the cover again, so that it audibly
latches into place.
Start-up
Measuring length
Press the ON/OFF button
9
to switch the
product on. If you do not press any button for
60 s, the display
10
shuts down.
To switch the product off manually, hold the
ON/OFF button pressed down for 3 seconds,
until the display goes out and a double tone
signal sounds.
Press the MODE button
8
repeatedly, until
the display shows the symbol for length meas-
urement “
“ as well as the length designa-
tion 0.00 m (or 0‘00“).
Hold the reference area
6
of the product at
the start point of your measurement. Hold the
product in such a way, that the reference
To Next Page
Loading...
