14 GB/IE/NI
Press the RECALL button. The measured value
is then transferred to the aggregate memory,
and the aggregate of the two measured
lengths appears at the bottom of the display.
If the measurement is an incorrect measure-
ment, do not press the RECALL button but
press the READ button again. The measured
value, which is displayed at the top, is over-
written. Press the RECALL button to adopt the
value into the aggregate memory.
You can repeat this procedure as often as
you wish, as long as the length of 9999.99 m
is not exceeded.
Measuring surface area
Note: In order to avoid errors in the measuring
method, please familiarize yourself first with the
information about measuring lengths.
Press the ON/OFF button
9
to switch the
product on.
Press the MODE button
8
repeatedly until
the symbol for surface area measurement
“
“, as well as the designation 0.00 m
(or 0‘00“), appear in the display
10
. The
symbol “
“ for length measurement flashes.
The product displays in this way, that it is
ready for the first measurement.
Align the product and press the READ button
4
.
If the measurement is successful, the length will
appear at the top of the display. The symbol
for width measurement “
“ also flashes.
The product displays in this way, that it is
ready for the measurement of the width.
To Next Page
Loading...
