Powerlink A713VS - Air Cleaner; Engine Coolant



6.4 Air Cleaner
6.4.1 Clean air ilter element
1)Loosenclipsontheaircleanerhousingandre-
movethedustcap.
2)Removetheairlterelement.
3)Blastthecompressedairtotheairlterelement
frominside.
4)Useacleanclothtowipetheltersealingsurface
andtheinsideoftheoutlettube.
5)Reinstalltheaircleanerinthereverseorder.
6.4.2 Change air filter element
1)Loosenclipsontheaircleanerandremovethe
dustcap.
2)Removetheairlterelement.
3)Changeanewairlterelement.
4)Reinstalltheaircleanerinthereverseorder.
6.5 Engine Coolant
Change coolant
Do not open the coolant filler cap when the engine
is hot, except in emergencies, as this could cause
serious personal injury. Steam or hot fluid could
spray out.
IMPORTANT:
The coolant contains corrosion-inhibiting
additives. Never drain the engine cooling system
on engines, which are to be put in storage.
1 Stop the engine before draining the coolant.
2 Remove the caps to both the expansion tanks
(1and 2) and radiator (3).
3 Place a suitable vessel for the coolant to drain
off into.
4 Open all drain points (4). Drain the coolant from
theradiator and engine block using a drain hose.
5 Check that all coolant drains out. Clear away
any deposits found inside the drain tap/plug.
There is otherwise a risk that coolant will remain
and cause freeze bursting. Check whether the
installation has any further taps or plugs at the
lowest points of the coolant lines.
6 Shut any taps and check that the spring-
loaded covers on the nipples close completely.
Install the rubber plugs.
4
3
1
2
CHAPTER 6 — MAINTENANCE
40