PowerMaster PXD Series User Manual

2.2 SETTING ADJUSTMENTS :
2.2.1 SETTING THE TORQUE
For desired torque Refer Table 1 conversion chart supplied for your PXD Series tool model. Read across to the corresponding pressure.
This pressure is to be set on the pump.
1. Hydraulic Power Pack is connected to the power supply and turns the pump on.
2. By Pressing the remote control button and holding it for some times all the pressure to build up on the gauge of the Hydraulic
Power Pack.
3. Adjust the pressure by loosening the lock nut that locks the pressure adjustment thumbscrew. Rotate the Thumbscrew clockwise
to increase the pressure and anticlockwise to decrease the pressure.
4. When decreasing pressure, it is necessary to turn the thumb-screw to a pressure setting BELOW what is desired and gradually
increase the pressure to the desired level.
5. When the required pressure is achieved then retighten the lock nut and cycle the tool again to confirm that the required pressure
setting has been obtained.
2. Operation
7
PXD Series Operation Manual

PowerMaster PXD Series Specifications

General

Brand	PowerMaster
Model	PXD Series
Category	Power Tool
Language	English