Questions? Call Toll Free at 1-800-737-2112 Copyright © 2019 MAT Engine Technologies, LLC
EN - 11
Operation (Continued)
• Save all instructions
How to Stop the Edger
C
Release the start lever (See Figure 6). This will ground out
the engine through the ground wire, causing the engine
to stop.
How to Change the Edger Cutting Depth
D
Move the Depth Control Lever forward to increase the
depth. (See Figure 7)
NOTE: There are 5 cutting depth settings from
approximately ground level to 2.5” (63 mm) deep.
NOTICE
Do not overload the edger capacity by attempting to edge
too deep at too fast a rate. To edge at deeper settings,
make multiple passes, first cutting at shallow depths.
How to Change the Blade Angle for a Beveled Edge
E
The blade can be adjusted 15 degrees from vertical (both
directions) to provide a beveled cut, which will cut the
grass further away from the sidewalk or driveway, reducing
the need to edge as often. Using the beveled edge at a
deep depth will cut a trench into the ground.
1. Stop the engine.
2. Disconnect the spark plug wire from the spark plug.
3. Disengage the index lever (See Figure 8). Move the
index lever to the desired notch (15, 0 or -15 degrees).
4. Before you start the engine, line up the edger as if you
were going to bevel cut.
NOTICE
Do not overload the edger capacity by attempting to edge
too deep at too fast a rate. To edge at deeper settings,
make multiple passes, first cutting at shallow depths.
Depth Control
Lever
Full Depth
Start Position
Forward
Depth Selector
Plate
Figure 7
Lever
Figure 8
7. After the engine starts, wait 2-5 seconds and rotate the
choke back to the RUN position.
8. If engine fails to start after 5 or 6 more attempts, see
instructions in the TROUBLESHOOTING CHART.
How to Start Engine (Continued)
B
WARNING
Keep hands, feet, hair, and loose clothing away from any
moving parts. Avoid touching muffler and surrounding areas
temperatures can exceed 150 degrees. Keep all safety
devices and shields in place.
WARNING
The ground wire terminals must be securely connected for
the Start Lever to function. Refer to the ”How To
Assemble The Handle” section on page 7.
To Next Page
Loading...
Need help?
General