Need help?Do you have a question about the Powermatic 1150A and is the answer not in the manual?
General| Type | Drill Press |
|---|---|
| Swing Over Bed | 15 inches |
| Motor | 1 HP |
| Swing | 15 inches |
| Spindle Travel | 4 inches |
| Spindle Taper | MT2 |
Details the warranty terms, limitations, and procedures for Powermatic products, including exclusions and consumer rights.
Covers electrical grounding, eye protection, personal attire, and work area cleanliness for operator safety.
Emphasizes guard usage, proper operator position, avoiding distractions, and securing workpieces.
Focuses on maintaining tools, using correct speeds/feeds, chuck key removal, and hand safety.
Covers spindle rotation, adjustments, capacity limits, preventing accidental starts, and disconnection for service.
Addresses misuse, unauthorized modifications, operation under influence, and health hazards from dust exposure.
Explains the meaning of CAUTION and WARNING symbols used throughout the manual.
Instructions for checking the drill press upon arrival for damage and preparing it for assembly.
Steps for mounting the machine on a solid foundation and raising the head to the correct working height.
Specific assembly instructions for multiple spindle models, including leg attachment and table leveling.
Detailed steps for installing or replacing the motor on the 1150A Step Pulley model.
Instructions for motor and pulley installation on 1150HD variable speed models.
Procedures for changing spindle speeds on both step pulley and variable speed models.
Step-by-step guide for properly installing and removing the drill chuck onto the spindle.
How to compensate for wear between the quill and head casting by adjusting a specific bolt.
Instructions for adjusting the quill return spring tension, primarily if a multi-spindle head is used.
Detailed procedure for removing and replacing the spindle assembly from the quill.
Guidance on lubricating specific points of the drill press for optimal performance and longevity.
Explains the technology and function of the AC inverter drive for variable speed control on the 1150HD model.
Instructions for connecting the 1150HD drill press to power, specifying single/three phase and voltage requirements.
Details how to use the optional foot switch for reversing spindle rotation during tapping operations.
Identifies and explains the function of each control on the drill press, referencing Figure 10.
Provides practical advice for safe and efficient operation, including workpiece securing and speed selection.
To Next Page
