Need help?Do you have a question about the Powermatic 1150HD and is the answer not in the manual?
General| Spindle Travel | 2-1/2 inches |
|---|---|
| Spindle Taper | No. 2 Morse Taper |
| Table Size | 7-1/2 x 7-1/2 inches |
| Base Dimensions | 12-1/2 x 12-1/2 inches |
| Type | Drill Press |
| Voltage | 115/230V |
| Spindle Speed | 250-3050 RPM |
| Swing | 15 inches |
| Motor | TEFC |
| Table Tilt | 45 degrees left and right |
Covers unpacking, checking for damage, cleaning, and mounting the drill press on a solid foundation.
Details motor mounting, belt tensioning, and procedures for changing speeds on step pulley and variable speed models.
Covers power connection for the electronic variable speed system and optional foot switch operation.
Identifies and describes the main operating controls of the drill press for user familiarity.
Provides guidance on proper setup, workpiece securing, speed selection, and drilling techniques.
Lists common problems like vibration, motor stalls, and noisy operation with their probable causes and remedies.
Addresses issues such as drills heating up, leads going off, drill runout, and workpieces coming loose.
To Next Page
