Why Powermatic 2013 table will not tilt?
If the table of your Powermatic Saw will not tilt, it could be because the trunnion is not lubricated, so lubricate it. It could also be that the trunnion is jammed, so disassemble and replace the jammed parts.
What to do if Powermatic Saw blade can not be tensioned properly?
If the blade on your Powermatic Saw cannot be tensioned properly, it may be because the tension springs are fatigued. If this is the case, replace the tension springs.
General| Motor | 1-3/4 HP, 1 Ph, 115/230V (Prewired 115V) |
|---|---|
| Voltage | 230 V |
| Amperage | 15 A |
| Cutting Capacity (Height) | 3-1/8 inch |
| Max Cut Depth at 90° | 3-1/8 inch |
Details what defects are covered, who is covered, and warranty periods.
Instructions for obtaining service and warranty limitations.
Essential safety rules for machine setup and operation.
Guidelines for safe use, environment, and tool handling.
Overview of the band saw, its specs, and key features.
Steps for unpacking, setting up, and assembling the band saw.
Guidance on connecting power, including voltage conversion.
Procedures for adjusting table tilt and blade guides.
Instructions for installing, tensioning, tracking, and selecting blades.
How to perform various cuts like ripping and crosscutting.
Solutions for operational, mechanical, and electrical problems.
Detailed lists and diagrams of machine components.
Wiring diagrams for different voltage and phase configurations.
To Next Page
