27
6.32 TCP / UDP Switch
Send command: "gprs+password,0,0" switch back to TCP mode, this is the
default mode.
Send command:"gprs+password,1,1" switch to UDP mode.
6.33 Configure parameters by USB
Connect the gps tracker to computer with the optional USB cable ,find gps
tracker’s internal memory and open serial debugging tool
in the format of text , refer to the instructions for more operations .
Note: Correct password is need every time you configure the tracker.
6.34 GPRS setting
User must send SMS via cell phone to set up IP, port and APN before starting
GPRS.
6.34.1 Setting up APN
6.34.1.1 APN standards for Access Point Name and differs from country to
country. For more information about the local APN, inquire with your local
GPRS network operator.
6.34.1.2 Text the tracker a SMS “APN+password + Space + your local APN”
via a cell phone and if succeeded in setup, the tracker will return the message
“APN OK”.
6.34.1.3 e.g. send SMS command “APN123456 CMNET”. If succeeded, “APN
To Next Page
Loading...