Powerplus POW8002 - 9 Cleaning and Maintenance; Cleaning; Maintenance; 10 Technical Data

POW8002 EN
Copyright © 2015 VARO P a g e | 9 www.varo.com
9 CLEANING AND MAINTENANCE
note: always ensure that the saw is turned off and the plug is removed from
the mains supply before any repairs or maintenance are carried out.
9.1 Cleaning
 After each use brush off any wood chippings with a soft brush. Pay special attention to the
inside of the dust extraction port (where the dust bag fits to the saw) as this is where there
will be a large build up if left for extended periods.
 The motor of the saw should be cleared of any wood chippings as there would be a risk of
fire if they are allowed to build up over time (a soft brush or dry air could be used to clear
the motor).
 Empty the bag after each use; there is a zip on the bag to allow for easy disposal of wood
chippings.
 Ensure the blade guard is kept clean with a damp cloth (do not clean the guard or any part
of the saw with a corrosive solvent) to reduce the risk of injury.
 Periodically oil all the moving parts on the saw to extend the life of the saw.
9.2 Maintenance
Our machines have been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper machine care and
regular cleaning.
10 TECHNICAL DATA
Voltage – frequency
230-240V – 50Hz
Power rating
1400W
No load speed
5000min
-1
Blade size
Ø 210mm
Max cutting depth
50mm
Bore size
Ø 25.4mm
Number of teeth
24
Max cutting capacity
0° x 90°
50mm x 120mm
45° x 90°
30mm x 120mm
0° x 45°
50mm x 80mm
45° x 45°
30mm x 80mm
11 NOISE
Noise values measured according to relevant standard. (K = 3)
Acoustic pressure level LpA
89 dB(A)
Acoustic power level LwA
102 dB(A)
Noise emission values measured according to relevant standard. (K=3)
aw (Vibration)
2.7 m/s²
K = 1.5 m/s²