USING THE HIGH PRESSURE HOSE
WARNING:
Injection hazard. Fully unwrap and straighten high pressure hose prior to and during each use
and do not allow it to become kinked. The high pressure hose features an outer covering that
provides strength to the hose. If the outer covering becomes damaged, stop using the hose and replace it
immediately. A kinked or damaged hose can develop a high pressure leak and result in a possible
injection or other serious personal injury.
To prevent damage to the outer covering:
Inspect the hose before every use.
Fully unwrap and straighten hose before use.
Do not allow the high pressure hose to be kinked.
Keep hose away from hot surfaces and sharp edges.
Do not pull unit by high pressure hose.
Do not allow hose to be crushed or wrapped around objects.
WASHING WITH DETERGENT
WARNING:
USE ONLY DETERGENTS DESIGNED FOR PRESSURE WASHERS. Do not use
household detergents, acids, alkalines, bleaches, solvents, flammable material, or industrial
grade solutions, which can damage the pump or cause property damage. Many detergents may require
mixing prior to use. Prepare cleaning solution as instructed on the solution bottle. Always test in an
inconspicuous area before beginning.
Disconnect pressure washer from power supply.
Pour detergent in the soap tank. Use a funnel, if needed, to prevent accidental spilling of the
detergent outside the tank. If any detergent is spilled during the filling process, make sure the unit is
cleaned and dried before proceeding.
MAINTENANCE
WARNING:
Before inspecting, cleaning, or servicing the machine, shut off motor, wait for all moving
parts to stop, disconnect unit from power supply, and pull trigger to release water pressure.
Failure to follow these instructions can result in serious personal injury or property damage.
WARNING:
Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure
to do so could result in objects being thrown into your eyes, resulting in possible serious
injury.
WARNING:
When servicing, use only identical replacement parts. Use of any other parts could create a
hazard or cause product damage.
NOTICE:
Periodically inspect the entire product for damaged, missing, or loose parts such as screws, nuts, bolts,
caps, etc. Tighten securely all fasteners and caps and do not operate this product until all missing or
damaged parts are replaced. Please call customer service or contact an authorized service center for
assistance.
To Next Page
Loading...
