Powersmart DB1002 - Symbols

7
SYMBOLS
Some of the following symbols may be used on this product. Please study them and learn their meaning.
Proper interpretation of these symbols will allow you to operate the product better and safer.
The following signal words and meanings are intended to explain the levels of risk associated with this
product.
SYMBOL
NAME
DESIGNATION/EXPLANATION
V
Volts
Voltage
A
Amperes
Current
Hz
Hertz
Frequency (cycles per second)
W
Watts
Power
Alternating Current
Type of current
no
No Load Speed
Rational speed, at no load
.../min
Per minute
Revolutions, strokes, surface speed, orbits, etc., per
minute
Safety Alert
Precautions that involve your safety.
Read the user’s
manual
To reduce the risk of injury, user must read and understand user’s
manual before using this product.
Eye protection
Wear eye protection when operating this equipment.
Wet Conditions
Alert
Do not expose to rain or use in damp locations.
Keep bystanders
away
To reduce the risk of injury, user must keep all bystanders at least 49
ft (15 m) away.
Risk of Injection
To reduce the risk of injection or injury, never direct a water stream
towards people or pets or place any body part in the stream. Leaking
hoses and fittings are also capable of causing injection injury.
Do not hold hoses or fittings.
Risk of Explosion
Do not spray flammable liquids. Flammable liquids and their vapors
are explosive and can cause severe burns or death.
Kickback
To reduce the risk of injury from kickback, hold the spray wand
securely with both hands when the machine is on.
Electric Shock
Do not use near electric power lines or receptacle outlets.
Chemical Burns
To reduce the risk of injury or damage, DO NOT USE ACIDS,
ALKALINES, BLEACHES, SOLVENTS, FLAMMABLE
MATERIAL, OR INDUSTRIAL GRADE SOLUTIONS in this
product.