STORING THE PRESSURE WASHER
NOTE: Regular use of pump protector will give you better performance of the unit and increase
the life of the pump. Store in a dry, covered area where the weather can’t damage it. It is important to
store this product in a frost-free area. Always empty water from all hoses, the pump, and the soap tank
before storing.
Make sure the on/off switch is in the OFF position.
Disconnect both the high pressure hose and the garden hose from the pump.
Tilt the unit to allow any remaining water in the pump to drain from the water inlet.
NOTICE:
If the location where your pressure washer is stored will fall below 32°F, the use of a pump protector is
required before storing to prevent freeze damage. Freeze damage will void your warranty.
Store the unit and accessories in an area that does not reach freezing temperatures. Do not store near
furnace or other sources of heat that could dry out the pump seals.
TROUBLE SHOOTING
WARNING: Read instruction manual first! Remove plug from power source before making
adjustments or assembling accessories.
Motor will not start.
1. On/Off switch is in the “OFF”
(O) position.
2. Power cord is not plugged in.
3. Electrical outlet does not
supply adequate power.
4. Tripped pressure washer
circuit breaker.
5. Power switch is ON however
gun trigger is not squeezed ON.
1. Set switch to the “ON” ( | ) position.
2. Plug in power cord.
3. Try a different outlet.
4. Allow to cool, and restart unit.
5. With power switch ON push in on the
gun
trigger which will engage the AUTO ON
switch.
Unit does not reach high
pressure.
1. Water supply is restricted.
2. Not enough water supply.
3. Pressure Tip has not been
installed on wand assembly
4. Water intake filter is clogged.
1. Check garden hose for kinks, leaks and
blockage.
2. Open water source fully.
3. Add desired pressure tip to end of wand.
4. Remove filter and rinse in warm water.
To Next Page
Loading...
