14.
15.
www.powertec.net.nz
www.powertec.net.nz
PT2000i DIGITAL INVERTER GENERATOR
(B) Remove the oil ller cap (1).
(C) Using the funnel ll with 0.4L of
SAE 10W-30 oil.
(D) Fill to required oil level.
Replace oil ller cap and secure side panel
with screws.
Adding Fuel
The fuel tank holds 5 litres.
DO NOT overll the tank, otherwise it may
overow when the fuel warms up and
expands.
NOTE: For safety reasons, once fuel has
been added to this unit it cannot be returned
to the place of purchase.
1. Use clean, fresh, regular unleaded fuel
with a minimum octane rating of 91.
2. DO NOT mix oil with fuel.
3. Clean area around the fuel cap.
4. Remove the fuel cap.
5. Be sure that the fuel strainer is in place.
6. Slowly add fuel to the tank up to the red
line. (E) DO NOT overll.
7. DO NOT ll above fuel strainer.
8. Screw on the fuel cap and wipe away any
spilled fuel.
NOTE: Check fuel and oil level each time
before use.
B.
C.
D.
E.
In order to add motor oil you will need to re-
move the side panel from the unit.(A) Using
Phillips-head screwdriver remove screws to
remove the side panel.
To Next Page
Loading...