PowerTec PT2200i - Troubleshooting Engine Problems

28.
29.
www.powertec.net.nz
www.powertec.net.nz
PT2000i DIGITAL INVERTER GENERATOR
PROBLEM (SYMPTOMS)
Engine does not start
Generator won’t
produce power
RECOMMENDED ACTION
IF PROBLEM PERSISTS
1. Turn engine switch to “ON”,
pull recoil starter.
2. Check fuel. Fill if empty. See pg
15 for more information
3. If oil warning light ickers check
oil level. If low, add engine oil.
See pg 14 for more information.
4. Check sparkplug. (TORCHA5RTC)
Clean if necessary or adjust/
replace gap. Gap: 0.6 - 0.7mm
(0.024 - 0.028”) See pg 22 for
more information
5. Check fuel lter - See pg 26.
Carburettor - See pg 22.
Air lter - See pg 24.
Maintain/service if necessary.
1. Check safety device (DC
protector) is “ON”.
2. Turn safety device (AC) to “OFF”.
Stop engine and re-start.
If all recommended
possible areas of
misadjustment have
been checked and
the problem persists,
contact your local
Powertec Authorised
Service Facility
Engine Problems
Troubleshooting