26.
27.
www.powertec.net.nz
www.powertec.net.nz
PT2000i DIGITAL INVERTER GENERATOR
Engine
Perform the following steps to protect the
cylinder, piston ring, etc. from corrosion.
1. Remove the spark plug, pour about one
tablespoon of SAE10W-30 motor oil into
the spark plug hole and reinstall the spark
plug. Recoil start the engine by turning
over several times (with ignition off) to
coat the cylinder walls with oil.
2. Pull the recoil starter until you feel com-
pression. Then stop pulling (this prevents
the cylinder and valves from rusting).
3. Clean exterior of the generator and apply
a rust inhibitor.
4. Store the generator in a dry, well-ventilat-
ed place, with the cover placed over it.
5. The generator must remain in a vertical po-
sition when stored, carried, or operated. 6.
Remove the screws (1), and then remove
the cover (2).
7. Drain the fuel from the carburettor by
loosening the drain screw (3) on the car-
burettor oat chamber.
8. Turn the 3-in-1 switch to “OFF”
9. Turn the fuel cock knob to “OFF”
10. Tighten the drain screw
11. Install the cover and tighten the screws.
12. Turn the fuel tank cap air vent knob to
“OFF”
13. Store the generator in a dry, well-ventilat-
ed place, with the cover placed over it.
A.
2
1
To Next Page
Loading...
