18.
19.
www.powertec.net.nz
www.powertec.net.nz
PT2000i DIGITAL INVERTER GENERATOR
4. Pull slowly on the recoil starter until it is
engaged, then pull it briskly.
NOTE: Grasp the carrying handle rmly to
prevent the generator from falling over when
pulling the recoil starter.
5. After the engine starts, warm up the engine
for several minutes to stabilize, or until the
engine does not stop when the 3-in-1 switch
is returned to the “ON” position.
NOTE: When starting the engine, with the
ESC switch “ON”, and there is no load on
the generator:
• In ambient temperature below 0ºC, the en-
gine will run at the rated r/min (4500r/min)
for 5 minutes to warm up the engine.
• In ambient temperature below 5º, the en-
gine will run at the rated r/min (4500r/min)
for 3 minutes to warm up the engine.
• The ESC unit operates normally after the
above time period, while the ESC is “ON”.
Starting the Engine
WARNING!
Operate the engine in a well ventilated
area. Do not connect any electrical
devices to the outlets on the generator
before starting the engine.
1. Turn the ESC switch to “OFF”
2. Turn the fuel cap air vent knob to “ON”.
3. Turn the 3 in 1 switch to “CHOKE” .
NOTE: The choke is not required to start a
warm engine.
To Next Page
Loading...
