20.
21.
www.powertec.net.nz
www.powertec.net.nz
PT2000i DIGITAL INVERTER GENERATOR
CAUTION!
DO NOT connect 3-phase loads to the
generator.
DO NOT overload the generator.
7. Repeat steps 5-6 for each additional
appliance or tool
NOTE: When connecting generator to multi-
ple loads, ALWAYS connect the one with the
highest starting current rst and connect the
one with the lowest starting current last.
Battery Charging
Start the engine rst and allow it to reach
idle before connecting the generator to the
battery. Battery charging is performed using
the 12V DC outlet only.
1. Be sure the ESC switch is turned “OFF”
while charging batteries.
2. Be sure to connect the red battery charger
lead to the positive (+) battery terminal,
and connect the black lead to the
negative (-) battery terminal. DO NOT
reverse these positions.
3. Connect the battery charger leads to the
battery terminals securely so that they are
not disconnected due do engine vibration
or other disturbances.
4. Charge the battery by following the
instructions in the owner’s manual for the
battery.
5. The DC Circuit Breaker will turn “OFF”
automatically if the current exceeds rated
output.
6. To restart charging the battery, turn the
DC protector on by pressing its button to
“ON”
7. Refer to the owner’s manual for the
battery to determine charging times.
NOTE: Never start or stop the generator
with electric devices plugged in or turned on.
CAUTION!
The DC terminals may be used for
charging 12 volt automotive type
batteries only.
To Next Page
Loading...