PowerTec PT3300Ei - Troubleshooting; Generator Specifications

TROUBLESHOOTING
Problem Cause Solution
Generator will not start
No fuel Add fuel
Faulty spark plug Replace spark plug
Unit loaded during start up Remove load from unit
Generator will not start;
Generator starts but runs roughly
Low oil level
Fill crankcase to the proper level
Place generator on a flat, level surface
Choke in the wrong position Adjust choke
Spark plug wire loose Attach wire to spark plug
Generator shuts down during operation
Out of fuel Fill fuel tank
Low oil level
Fill crankcase to the proper lev
el. Place
generator on a flat, level surface
Generator cannot supply enough power or
overheating
Generator is overloaded
Review load and adjust. See “Power
Management”
Insufficient ventilation
Check for air restriction. Move to a well
ventilated area
No AC output
Cable not properly connected Check all connections
Connected device is defective Replace defective device
Circuit breaker is open Reset circuit breaker
Loose wiring Inspect and tighten wiring connections
Other C
ontact the help line
Repeated circuit breaker tripping
Overload
Review load and adjust. See “Power
Management”
Faulty cords or device
Check for damaged, bare or frayed wires.
Replace defective device
GENERATOR SPECIFICATIONS
Model
Engine model
Displacement
Type
Running watts
Starting watts
Voltage 230V
Rater Current 13 A
Phase Single
Frequency 50Hz
Fuel Capacity 14 L
208cc
PT3300Ei
PD230
3000
3300
4-Stroke OHV
22.
www.powertec.net.nz
PT3300Ei
3300W DIGITAL
INVERTER GENERATOR