Installation
4
Powerware
®
3115 User’s Guide
S
www.powerware.com
WARNING
S
ThisUPScontainsitsown energysource (batteries). The outputreceptaclesmay
carrylive voltageeven when the UPSisnot connected toan ACsupply.
S
Donot remove or unplug the inputcordwhen the UPS is turnedon. This removes
the safetyground from theUPSand the equipment connected to theUPS.
S
To reduce therisk offireor electricshock,installthisUPSina temperature and
humiditycontrolled,indoorenvironment,freeofconductivecontaminants.Ambient
temperature mustnot exceed 40
°
C (104
°
F).Do notoperate near water or
excessive humidity (95% max).
Installing the UPS
The following steps explain how to install the UPS. See “UPS Rear
Panels” on page 6 for the rear panel of each model.
1. If you are installing the power management software, connect
your computer to the UPS communication port using the
supplied communication cable.
NOTE If you need to change the factory-setdefaultsfor outputvoltageor utility
power range,see “How to SetDIP Switches”on page10 before installing the UPS.
2. On 230V models, plug the UPS power cord into the input
connector on the UPS rear panel.
3. Plug the UPS power cord into a wall outlet or other power
source.
4. Plug the equipment to be protected into the UPS output
receptacles.
DO NOT protect laser printers with the UPS because of the
exceptionally highpower requirements of the heating elements.
To Next Page
Loading...
