POWERWINCH RC 23 & RC30 TRAILER WINCHES
3
Programming a Replacement Remote
1. Connect the 12V power cable to the winch.
2.
7.
Release the clutch knob and pull the cable out
about 4 feet.
Hold down the up position of the toggle on the back of
the winch.
When the LED on the winch lights up, release the
Wait for the light on the winch to flash 4 times, and turn off.
Hold the on/off button on the key fob until the LED on the winch flashes once.
After the LED has flashed one time, tighten the clutch knob and press the ↑
button on the key
fob to run the cable in. Press the light button on then off to
test the LED.
• The transmitter (remote) is an electronic device and should be kept dry at all times.
• The remote operates best within a 10'-15' range from the winch (receiver).
Maximum operating distance is 30'- 40'. Actual distance may vary depending on
the environment the remote is used in.
• For best operation, hold the remote level with or above the winch.
• The transmitter and receiver have been tested and complies with the limits for a
Class B digital device pursuant to Part 15 of the FCC Rules.
This equipment generates, uses and can radiate radio frequency energy. There is
no guarantee that interference will not occur in any particular installation. This
interference may affect radio and television reception.
• To prevent accidental operation of the winch and to preserve battery life, the
remote must be turned off after every use.
Replacing the Remote Battery
The remote uses a 12V size A23 battery. Batteries are available through your local
battery outlets. For best performance, the battery should be changed every 3
months or twice during the boating season. Actual battery life is dependent on
frequency of use, environmental conditions and the condition of the remote.
1. Remove the small screw from the back of the remote.
2. Carefully separate the two halves of the remote.
NOTE: When removing the old battery, make note of the polarity of the
battery. When inserting the new battery, place the negative end against the
coil spring terminal.
3. Remove the old battery and insert the new battery.
4. Reattach the covers and screw removed previously.
Press to Learn
Manual Override
pwRC009
4.
Remote Operational Notes
8.
3.
6.
toggle.
5.
Press the ↑ button on the key fob until LED flashes one time. Then release.
To Next Page
Loading...
