PowerXtreme X30 - Installation Precautions; Initial Checks and Charging; Hazardous Location Warning; Mounting, Clearance, and Ventilation

User manual PowerXtreme X20/X30
E18-X20X30-EN00 www.emergoplus.com Page 15 of 25
▪ After unpacking, check all parts for possible damage.
▪ Fully charge the battery before first use.
▪ Mount the battery pack using the supplied mounting plate and
Velcro fastener at the location of your choice in the camper.
▪ Make sure there is at least 10 cm clearance around the battery. Do
not install the LiFePO4 battery in an unventilated area, there is a
risk of overheating!
▪ Switch off all loads and charging equipment before you start
connecting.
▪ Use proper cabling of sufficient cross-section and correctly
dimensioned terminals and battery terminals. Tighten all
WARNING!
Never use the LiFePO4 battery in locations with
gas or dust explosion hazards or potentially
flammable products.
PAY ATTENTION!
De meegeleverde accupolen hebben
verschillende diameters, de dunste is voor de
negatieve pool, de dikste voor de positieve pool.
Figure 3. Difference diameter of + and - pole