PowMr Keeper Series User Manual

8
a) Float voltage set up
This parameter is high voltage disconnection (HVD) voltage. (Boost state voltage will be increase
0.6V base on HVD). The controller will be started PWM function at this point (HVD), limited voltage
rising.
Press "menu" button join in float voltage menu.
Long press "menu" button more than 5st the parameter on the interface will be flash, here is set up
state. Loose the button, press "menu" button again could operate plus data, press "set" button
could operate minus data. After finish required technical data, long press "menu" button again more
than 5s, the parameter save and come out set up state, if 20s no any operation, automatically back
to main interface.
b) Low Voltage Reconnect Voltage (LVR)
When the voltage of battery is low, the control will stop offer power to the load. If the controller
needs reconnected the output, the voltage of battery must be higher than LVD voltage or press
'"set" button force to release, The procedure is same with (a).
c) Low Voltage Disconnect Voltage (LVD)
When the voltage of battery is low, the load output will be cut off. When the controller detected the
battery voltage was less than LVD point, the cut off function will be immediately working. At the
same time, the status of controller is in lock. Users have to charge the battery, when the battery
voltage is higher than LVD voltage or press “set" button force to release. The load output will be
back. The procedure is same with (a).
Long press MENU 5s
20s later

PowMr Keeper Series Specifications

General

Brand	PowMr
Model	Keeper Series
Category	Controller
Language	English