Version: 1.0 9
Installation Instructions
Surface mounting
5
Adhesive surface mounting
• Clean the entire surface on which you plan to
stick the antenna
• Remove Nut, spigot seal and Short spigot from
antenna
• Push the Rf cable into the groove in the plastic
base
• Secure cable with the 2 x cable clips and
4 x (M4 x 12mm) stainless steel screws
• Pull off the one side of the adhesive wax paper of
each of the 6 x adhesive foam discs
Double sided
Adhesive foam discs
Magnets
Non-slip rubber
adhesive discs
M4 x 12 Stainless steel
screws
Adhesive surface mount
M4 x 12 Stainless steel
screws
Cable clips
RF Cable
Optional magnetic base kit
To Next Page
Loading...
