16
BOARD COMMAND
Check the label attached to the
product (according to the model on
the side) which is the board part of
the operator. After doing this, refer
to the board manual that is available
for download at www.ppa.com and
make all connections and settings.
Lote:
Code:
Model:
Reduction:
Technology:
Voltage:
Board:
Size:
Assembly:
Fairing:
Gear:
MAINTENANCE
In the table below, we will mention some PROBLEMS - DEFECTS, PROBABLE
CAUSES AND CORRECTIONS - which may occur in the operator. Before any
maintenance, it is necessary to completely disconnect the mains.
DEFEITOS PROBABLE CAUSES CORRECTIONS
Engine does not
start / does not
move
A) Power off
B) Open/ burned fuse
C) Locked gate
D) Defective limit switch
A) Make sure the mains power is
turned on correctly
B) Replace fuse with the same
specification
C) Make sure that there are no objects
blocking the operation
D) Replace the limit switch system
(analog and/ or digital)
Motor blocked
A) Inverted motor connection
B) Locked or trigger gate
A) Check the motor wires
B) Set to manual mode and check
separately
Electronic board
does not accept
command
A) Burned fuse
B) Power off (power)
C) Defect on remote control unloaded
D) Transmitter range (remote control)
A) Replace the fuse
B) Turn on the power (power)
C) Check and replace the battery
D) Check the position of the receiver
antenna and, if necessary, reposition
the ensure
Motor only turns
to one side
A) Inverted motor wires
B) Inverted limit switch system
C) Defect in the command board
A) Check the motor connection
B) Invert the limit switch connector
(analog and /or digital)
C) Replace the board
To Next Page
Loading...
Need help?
General
