PPM CD30 - Summary; Wiring; CD30;35 Important Menu Settings; Step by Step Setup Procedure

To Next Page

To Previous Page

P/N SM1222

Rev 6

Print Date 2/14/2018

Table of Contents

1. Summary

1.1. Controller Specifications

1.2. Application

1.3. Safety Instructions

2. Wiring

2.1. Power (incoming to controller/outing to coil)

2.2. Feedback Sensor

2.3. System control wiring

2.3.1. Enable Unit

2.3.2. External Set Point (C038~ESP)

2.3.3. Status Relay (C040~r.b.)

2.3.4. 2

Set Point (C038~2.)

2.4. Recommended Method for Installing a Frequency Controller

3. CD30/35 Important Menu Settings

3.1. Basic Display Navigation

3.2. C210, C143, C117, C127 (Save & Hide Settings)

3.3. C038 (Function Settings)

3.4. C040 (Service Settings)

4. Step by Step Setup Procedure

4.1. Wire CD30/35

4.2. Set CD30/35 Menu Settings for PPM equipment

4.3. Set Sensor Position using C051

4.4. Run Automatic Frequency Search (AFS)

4.5. Set Operating Characteristics (A, P)

4.6. Save User Settings & Hide Menus

5. Main Fault Messages

6. Troubleshooting

7. Special Applications

7.1. Master/Slave Control

7.2. Single Controller for Multiple Magnet Coils

CD30/35 Quick Start Addendum