Need help?Do you have a question about the PPM CD30 and is the answer not in the manual?
Details the electrical and operational specifications of the CD30/35 controller.
Lists the PPM equipment models that the CD30/35 controller has been tested with.
Provides essential safety instructions and warnings for the product's correct application.
Explains incoming plant power and outgoing power to the coil connections.
Details the wiring for DMT/Mag II sensors and PPM accelerometers.
Covers wiring for unit enablement, external set points, status relay, and second set points.
Recommends methods and components for installing a frequency controller.
Explains how to navigate the controller's display and settings menus.
Describes menu codes for hiding functions/service menus and saving/restoring settings.
Details the various function settings available within menu C038.
Outlines the service settings accessible within menu C040.
Guides on connecting incoming power, outgoing power, and feedback sensors.
Provides initial menu parameter settings for PPM equipment.
Explains how to adjust the sensor gap for proper operation.
Details the process of performing an AFS to find the conveyor's resonant frequency.
Guides on setting amplitude (A) and power (P) for optimal feeder performance.
Instructions on saving user settings and hiding configuration menus.
Lists and explains various error messages displayed by the controller.
Provides solutions for common feeder and controller operational problems.
Explains how to set up master/slave control for larger feeders.
Describes using a single controller for multiple magnet coils in parallel.
General| Contact Current Rating | 10 A |
|---|---|
| Coil Voltage | 3 VDC, 5 VDC, 6 VDC, 9 VDC, 12 VDC, 24 VDC, 48 VDC |
| Release Time | 5 ms |
| Mechanical Life | 10, 000, 000 Operations |
| Contact Rating | 10A @ 250V AC, 10A @ 30V DC |
| Electrical Life | 100, 000 operations |
| Insulation Resistance | 1000MΩ |
| Dielectric Strength | 1500V AC |
To Next Page