5725V101-IN 11
TTL input:
Trig-level LOW ............................................. ≤ 0.8 VDC
Trig-level HIGH ............................................ ≥ 2.0 VDC
Input impedance ......................................... ≥ 100 kΩ / < 1.5 nF
Sensor supply - pin 44, programmable ..... 5 -17 V / 20 mA
S0 input acc. to DIN 43864:
Trig-level LOW ............................................. ≤ 2.2 mA
Trig-level HIGH ............................................ ≥ 9.0 mA
Input impedance ......................................... 758 Ω / < 1.5 nF
Sensor supply - pin 44, fixed ...................... 17 V
Special voltage input:
User programmable trig-levels .................... -0.05...6.50 V
Hysteresis, min ............................................ 50 mV
Input impedance, selectable:
High Z .................................................... ≥100 kΩ / < 1.5 nF
Pull up and pull down............................ 3.48 kΩ / < 1.5 nF
Sensor supply - pin 44, programmable ...... 5 -17 V / 20 mA
Special current input:
User programmable trig-levels .................... 0.0...10.0 mA
Hysteresis, min ............................................ 0.2 mA
Input impedance ......................................... 1 kΩ / < 1.5 nF
Sensor supply - pin 44, programmable ..... 5 -17 V / 20 mA
Output:
Display:
Display readout ........................................... -1999...9999 (4 digits)
Decimal point .............................................. Programmable
Digit height .................................................. 13.8 mm
Display updating ......................................... 2.2 times / sec.
Input frequency outside range &
Namur input sensor error is indicated by....... Explanatory text
To Next Page
Loading...
Need help?
General