22 5725V101-IN
CONFIGURATION / OPERATING
THE FUNCTION KEYS
Documentation for the routing diagram
In general:
When configuring the display you are guided through all parameters, allowing
you to choose the settings which fit the application. For each menu there is
a scrolling help text which is automatically shown in the display if no key has
been activated for appr. 5 seconds.
Configuration is carried out by way of the 3 function keys
1 2 and 3.
1 will increase the numerical value or choose the next parameter. 2 will
decrease the numerical value or choose the previous parameter.
3 will
accept the chosen value and go to the next menu. If a function does not exist
in the hardware, all parametres belonging to that function will be skipped in
order to make configuration as simple as possible. The configuration will not
be saved until the end of the menu structure when the display shows - - - -.
Pressing and holding
3 will return to the previous menu or go back to the
default state (”Monitor”) without saving the changed values or parameters.
If no key is activated for 2 minutes, the display will return to the default state
(”Monitor”) without saving the changed values or parameters.
Furhter explanations:
Fast setpoint adjustment and relay test: These menus are interactive and
allow you to adjust the setpoints while the display is measuring the input
signal. The diodes will then indicate when the relays change state, thus
easing the setpoint adjustment in many situations. By activating
1 and 2
simultaneously, a relay test will be initiated and the relay will change state.
The setpoint adjustment will be saved by a quick press of
3 . Holding
down
3 for more that 0.5 seconds wil return the display to the default state
(”Monitor”) without changing the setpoint.
To Next Page
Loading...
Need help?
General