Pramac P2000i - Fuel Filter Maintenance

INVERTER GENERATOR – P2000i
40
K Check the spark plug.
• Type: BPR6HS
• Gap: 0.6-0.7 mm (0.024-
0.028 in)
L
Incorrect
M
OK
Replace or
adjust Gap.
Clean the spark
plug.
N Check the following
• Fuel line clogging
• Air cleaner
element clogging.
O
Clogged
Q
Clean
or Replace; Consult a
dealer.
P
OK
R Consult a dealer.
7.2 Fuel Filter Maintenance
Use this section to troubleshoot common errors.
Engine won't start
Fuel systems: No fuel supplied to combustion chamber
• No fuel in tank supply fuel.
• Fuel in tank Fuel tank cap air vent knob to “ON” and fuel cock knob
to "I".
• Clogged fuel line…clean fuel line.
• Clogged carburetor…clean carburetor.
Engine oil system insufficient
• Oil level is low…add engine oil.
Electrical systems
• Engine switch to "I" and pull the recoil starter. Poor spark
• Spark plug dirty with carbon or wet... Remove carbon or wipe spark
plug dry.
• Faulty ignition system…Consult a service center.
Generator won't produce power
• Safely device (DC protector) to "O" …press the DC protector to "I"