Pramac P2000i - GETTING STARTED; Adding Engine Oil

INVERTER GENERATOR – P2000i
18
3 GETTING STARTED
3.1 Unpack the Generator
Remove the generator from its packaging.
WARNING
Packaging is flammable! Do not attempt to add fuel to this unit before removing it from
packaging.
Inspect the generator to ensure that no damage has occurred in shipping or
handling. If the unit appears to be damaged, DO NOT add fuel or attempt to
start the generator. Please call PRAMAC costumer service.
Check to ensure that you received the following items:
• P 2000i 2000W Generator
• Parallel Cables
• Oil Funnel
If you did not receive any of the above items, please contact PRAMAC
costumer service.
3.2 Adding engine Oil
The generator has been shipped without engine oil. DO NOT add fuel or start
the engine before adding engine oil.
Figure 1
NOTE
In order to add motor oil you will need to remove the side panel from the unit.